- Posts: 1738
- Thank you received: 134
Finished Clutch
- 1748 S
- Topic Author
- Offline
- Platinum Member
-
Registered
Less
More
21 Sep 2017 00:27 #33592
by 1748 S
Replied by 1748 S on topic Finished Clutch
Thanks Terry for the pics and dimensions. They sure will help insure my clutch is set correctly.
Please Log in or Create an account to join the conversation.
- Terry Cockerell
- Offline
- Elite Member
-
Registered
Less
More
- Posts: 1333
- Thank you received: 301
20 Sep 2017 10:02 #33588
by Terry Cockerell
T cockerell
Replied by Terry Cockerell on topic Finished Clutch
Attached is the diagram I used to set the pressure plate fingers. I set the flywheel, clutch and pressure plate up in my lather and used a dial indicator to adjust the screws for uniform readings. Good luck.
T cockerell
Please Log in or Create an account to join the conversation.
- 1748 S
- Topic Author
- Offline
- Platinum Member
-
Registered
Less
More
- Posts: 1738
- Thank you received: 134
20 Sep 2017 02:41 #33587
by 1748 S
Replied by 1748 S on topic Finished Clutch
bearing pics
Please Log in or Create an account to join the conversation.
- Terry Cockerell
- Offline
- Elite Member
-
Registered
Less
More
- Posts: 1333
- Thank you received: 301
20 Sep 2017 02:02 #33586
by Terry Cockerell
T cockerell
Replied by Terry Cockerell on topic Finished Clutch
The $43 quoted for the spigot shaft bearing seems steep. Mine cost around $10 Aust
The round headed screws in the pressure plate fingers look the same as mine and probably came from a Ford.
The key is having them adjusted at the correct height and all equal.
Towards smooth gear changes, money well spent.
I have a diagram for setting the fingers correctly , I will dig it out and add it to the posting. Your screws look a bit too high.
The round headed screws in the pressure plate fingers look the same as mine and probably came from a Ford.
The key is having them adjusted at the correct height and all equal.
Towards smooth gear changes, money well spent.
I have a diagram for setting the fingers correctly , I will dig it out and add it to the posting. Your screws look a bit too high.
T cockerell
Please Log in or Create an account to join the conversation.
- 1748 S
- Topic Author
- Offline
- Platinum Member
-
Registered
Less
More
- Posts: 1738
- Thank you received: 134
19 Sep 2017 20:10 - 19 Sep 2017 22:52 #33582
by 1748 S
Replied by 1748 S on topic Finished Clutch
more pics
Last edit: 19 Sep 2017 22:52 by 1748 S.
Please Log in or Create an account to join the conversation.
- 1748 S
- Topic Author
- Offline
- Platinum Member
-
Registered
Less
More
- Posts: 1738
- Thank you received: 134
19 Sep 2017 20:08 #33581
by 1748 S
Finished Clutch was created by 1748 S
Please Log in or Create an account to join the conversation.