- Posts: 1738
- Thank you received: 134
Transmission Clearances
- 1748 S
- Topic Author
- Offline
- Platinum Member
-
Registered
Less
More
17 Mar 2018 17:18 #34321
by 1748 S
Replied by 1748 S on topic Transmission Clearances
Thyank you Jim for the direction for needed information. I do have two of the club offered trans repair manuals. Sad part is the high lighted the demensions in one of those manuals but misplaced it. so I purchased another manual only to "find" the lost one after my questions. so I'm on my way and have made all the gear bushings. Plus I have installed the synchro clutches but have not staked them or cut them yet. at present my main shaft gear sleeve is out being hard chromed.
Please Log in or Create an account to join the conversation.
- JIM.OBRIEN
- Offline
- Premium Member
-
Registered
Less
More
- Posts: 585
- Thank you received: 217
17 Mar 2018 01:51 #34318
by JIM.OBRIEN
Replied by JIM.OBRIEN on topic Transmission Clearances
Check the transmission book.
Please Log in or Create an account to join the conversation.
- 1748 S
- Topic Author
- Offline
- Platinum Member
-
Registered
Less
More
- Posts: 1738
- Thank you received: 134
23 Feb 2018 19:15 #34219
by 1748 S
Transmission Clearances was created by 1748 S
As many know, I attempting to rebuild my trans. Sadly I do not know what acceptable running clearances are. I recognise we has thrust washers between most if not all the gears. Mine has some noticeable wear on them.So who or where can I get what all these tolerances are... Thanks for any help or directions.
Please Log in or Create an account to join the conversation.