Bustle Trunk Seal

  • wynlaidig
  • Topic Author
  • Offline
  • Forum Contributor
  • Forum Contributor
More
13 Feb 2019 02:17 #36627 by wynlaidig
Bustle Trunk Seal was created by wynlaidig
Can someone show me what profile seal should be on the bustle trunk? There is nothing on my car, and i am not sure what seal to use, or how it mounts.

Please Log in or Create an account to join the conversation.

  • Terry Cockerell
  • Offline
  • Frequent Forum Contributor
  • Frequent Forum Contributor
More
13 Feb 2019 08:31 #36629 by Terry Cockerell
Replied by Terry Cockerell on topic Bustle Trunk Seal
Stan should have this at AC Parts in Kansas. I would assume it has the same cross section as used on Westchesters .................... a hollow D section with a pre-glued flat side.

T cockerell

Please Log in or Create an account to join the conversation.

  • wynlaidig
  • Topic Author
  • Offline
  • Forum Contributor
  • Forum Contributor
More
13 Feb 2019 12:41 #36631 by wynlaidig
Replied by wynlaidig on topic Bustle Trunk Seal
No he doesn't have any. He has the smaller half round for the open cars but it is too small for the bustle trunk. If it's the same hollow D profile but just larger I can find it somewhere. I just didn't know for sure what it was supposed to be. Just knew the smaller open car seal didn't fit.

Please Log in or Create an account to join the conversation.

  • Terry Cockerell
  • Offline
  • Frequent Forum Contributor
  • Frequent Forum Contributor
More
13 Feb 2019 20:48 #36634 by Terry Cockerell
Replied by Terry Cockerell on topic Bustle Trunk Seal
I will check the dimensions of the D section used on my Westchester and let you know. I am sure there will be a supplier of an equivalent out there. I will ley you know later today ............................ I am in Australia.
Cheers,
Terry

T cockerell

Please Log in or Create an account to join the conversation.

  • Terry Cockerell
  • Offline
  • Frequent Forum Contributor
  • Frequent Forum Contributor
More
14 Feb 2019 03:53 #36637 by Terry Cockerell
Replied by Terry Cockerell on topic Bustle Trunk Seal
The Westchester trunk seal is D shaped and measures 13 mm x 13 mm with a 6 mm hole in the middle. The flat base is pre-glued with a tear off strip.
Hope this helps.

T cockerell
The following user(s) said Thank You: 1748 S

Please Log in or Create an account to join the conversation.

More
14 Feb 2019 04:25 #36638 by 1748 S
Replied by 1748 S on topic Bustle Trunk Seal
Thanks Terry. That helps me so much. I can find something with those dimensions for sure.


Gary Parsons

Please Log in or Create an account to join the conversation.

Moderators: Joe Holderman
Time to create page: 0.078 seconds
Powered by Kunena Forum